AFO Resources

AFO Portfolio

Turbomed XTERN

Richie Braces

Balance Brace

Dorsiflex Carbon AFOs

Gauntlet Braces

Traditional AFOs

Custom Walkers

Pediatric - UNFO Brace

Order Forms

Turbomed XTERN

Richie Braces

Traditional Braces

Dorsiflex Carbon AFOs

Gauntlet Braces


Turbomed XTERN Accessories

STS Slipper Socks

AFO L-Code Guide

DMEPOS Fee Schedule

Medicare Compliance

Same or Similar

A300 - Tamarack Dorsi-Assist

Custom congruent to patient using:
Plaster, STS, Fiberglass Roll, 3D Scanner, Existing Positive Model
Current timing for delivery is 3 weeks.
Expedited on availability.

Clinical Indications:

  • Paralytic equinis or “foot drop”
  • Adult acquired flatfoot stage III & IV
  • Mild PTTD (Posterior Tibial Tendon Dysfunction)
  • Talocalcaneal varus or valgus
  • Mild to moderate DJD (Degenerative Joint Disease)
  • Ankle instability
  • Mild to moderate pronation
  • Mild to moderate supination
  • Trauma

Recommended For:

  • Patients who require moderate to severe foot drop management as well as above indications

Product Details
The Tamarack Dorsi-Assist brace features a Tamarack joint and is ideal for patients with foot drop, but it can also be used to treat a variety of additional pathologies. The orthoses is pitched at 50 degrees in dorsiflexion but can be customized depending on the patient’s architecture and need. An extrinsic rearfoot post can be customized to varying degrees. An optional posterior bar provides more lateral and medial control, but independent uprights are recommended for easy donning. This device is constructed with a 4mm polypropylene frame that can be reduced to 3mm for flexibility or increased to 5mm or 6mm for greater control. Because the dorsi-assist joint provides full ankle range of motion without restrictive, it’s best for rehabilitative conditions.

This brace is formed over a positive model of the patient’s foot. A negative impression or scan above the height of the finished brace must be created to correct and hold the foot, ideally with the ankle at 90 degrees and in a semi-weight-bearing or full-weight position. The finished device is crafted by pulling a leather lining over the model, followed by the plastic layer and a final sewn leather top cover.

This device is fully customizable per the practitioner’s discretion and is available exclusively through licensed medical providers.

Ankle foot orthosis, plastic with ankle joint, custom fabricated
L2275 Addition to lower extremity, varus/valgus correction, plastic modification, padded/lined

L2820 Addition to Lower Extremity Orthosis, Soft Interface for Molded Plastic, Below Knee Section
L2210 Addition to lower extremity, dorsiflexion assist (plantar flexion resist), each joint
L2210 Addition to lower extremity, dorsiflexion assist (plantar flexion resist), each joint.